Starlight-xpress Oculus Manuel d'utilisateur télécharger pdf (Page 5)

Oculus handbook Issue 2 January 2013

Imaging with the Starlight Xpress software

With the Oculus connected to the PC, open ‘Oculus_USB.exe’ and find the ‘Set program defaults’

menu under the ‘File’ heading. If this is the first run of the software, you will get a warning about the

‘ini file not found’, but ignore this and click on OK – then open ‘set program defaults’ from the text

icon . You should now see a screen similar to the one shown below:

The defaults shown above are a typical example, but you can change the settings to suit your

preferences. The main thing to do is to set up the address of the ‘Autosave’ folder, so that your images

will be saved to a defined location. The ‘Ignore VID/PID’ may be selected if the software fails to

recognise your Oculus camera, but is not normally necessary. Once the defaults have been set to values

which you think will be approximately correct, save the settings and open the camera interface by

pressing the camera icon in the top menu. You will see something like this:

1 2 3 4 5 6 7 8 9

Pas de commentaire

Starlight-xpress Oculus Manuel d'utilisateur Page 5